1994 Dodge Viper

BACK TO PROJECTS

Fuel injected, Supercharged with N.O.S. heads by Klymenko flow.
Dyno stats and chart below
Viper Enthusiasts
Does your Viper leak or burn antifreeze ? Do you have head gasket leaks ? Problems with twisted half shafts ? We make all copper head gaskets for 92-98 Vipers to correct these problems. We also make custom half shafts capable of 1000 h.p. far stronger than the original . If you've have a Supercharged or N.O.S. Viper we can further enhance the performance with a timing retard system that is adjustable to remove up to 10 degrees of timing. We are currently testing a boost retard system for an independent company as well, so check back for the results on that. If you drive a Viper make it preform at its best, call us and we can set it up to run like it should.
SPECIFICS:
  • Dodge V-10 engine
  • Multi Port Fuel Injection
  • K Flow heads
  • NOS
  • MASSACHUSETTS EMISSIONS LEAGAL
DYNORUN.016 57.4deg. F 29.71-0.23 in.Hg 60ft. RPM/MPH=47
Max POWER = 699.6 Max TORQUE = 802.5
94 octane, 10psi boost, small shot of NOS starting at 2200 rpm.
Please note this was a break in run and was in a mild state of tune.
We are shooting for a figure of nearly 1000 ft. lbs. of torque at the
rear wheel which would be about 1150 ft. lbs. of torque at the crank.

.BACK TO PROJECTS

ACS Racing

74 Industrial Way

Hanover, Ma.02339

(781) 982-9434